P328 28" Plug-End Garage Door Spring (.244" #3 Wire)
Save on 28-Inch Plug-End Springs for One Piece Garage Doors!
 
Alternative Views:


P328 28" Plug-End Garage Door Spring

  • Direct replacement for Holmes-type springs used on garage doors equipped with the E900 jamb type hardware kit as well as certain toy haulers
  • Replacement spring for one piece / tilt-up garage doors
  • Safety containment to prevent it from coming loose
  • Handles 125 - 250 lb. garage doors
  • Minimum 1 in. low headroom required
  • Length over coils = 28 in.
  • Outside diameter = 2 in.
  • Wire diameter gauge = (0.244) #3
  • Initial tension = 165-185 lbs.
  • Maximum allowable stretch = 18.5 in.
MSRP: $64.99
Your Price: $44.99
Qty:

Description Technical Specs Spring Selection Chart
 
The P328 28" Plug-End Garage Door Spring is a Holmes spring replacement for 7 ft. or higher one piece garage doors. Two springs are required to operate the 7 ft. one piece door. This product is perfect for DIY garage door repair.

  • Replacement spring for one piece / tilt-up garage doors
  • Safety containment to prevent it from coming loose
  • Handles 125 - 250 lb. garage doors
  • Minimum 1 in. low headroom required
  • Length over coils = 28 in.
  • Outside diameter = 2 in.
  • Wire diameter gauge = (0.244) #3
  • Initial tension = 165-185 lbs.
  • Maximum allowable stretch = 18.5 in.

Average Rating: 5 of 5 Total Reviews: 1 Write a review »

  12 of 12 people found the following review helpful:
 
It was very easy to install and it... February 12, 2016
Reviewer: Lizzy Martin from San Diego  
...replaced the previous spring with no problem. It was very easy to install and works just like the one it replaced. I like that it wasn't too expensive, way less than the $500 the repairman quoted me!

Was this review helpful to you?