P920 20" Plug-End Garage Door Spring (.148" #9 Wire)
Save on 20 in. Plug-End Spring for 1-Piece Garage Doors!
 
Alternative Views:


P920 20" Plug-End Garage Door Spring

  • Direct replacement for Holmes-type springs used on garage doors equipped with the E900 jamb type hardware kit as well as certain toy haulers
  • Safety containment rod to prevent spring coils from coming loose
  • Maximum garage door weight limit is 75 lb.
  • Minimum 1 in. headroom required
  • Length over coils = 20 in.
  • Outside Diameter = 1-1/4 in.
  • Wire Diameter & Gauge = 0.148" (#9)
  • Initial Tension = 45-55 lbs.
  • Maximum Allowable Stretch = 18.5 in.
MSRP: $29.99
Your Price: $19.99
Qty:

Description Technical Specs Spring Selection Chart
 
The P920 20-Inch Plug-End One Piece Garage Door Spring is a Holmes spring replacement for 7 ft. or higher one piece garage doors. Two springs are required to operate the 7 ft. one piece door. This product is perfect for DIY garage door repair.

  • Replacement spring for one piece / tilt-up garage doors
  • Safety containment to prevent it from coming loose
  • Maximum weight limit is 75 lb.
  • Minimum 1 in. low headroom required
  • Length over coils = 28 in.
  • Outside diameter = 1-1/4 in.
  • Wire diameter gauge = (0.148) #9
  • Initial tension = 45-55 lbs.
  • Maximum allowable stretch = 18.5 in.
Download Holmes spring installation instructionsDownload spring installation guide >>

Share your knowledge of this product. Be the first to write a review »